Applying a seal coat to a table top or bar top is a simple procedure.

Step 1 - Mix up a small quantity of ProGlas 1000 Epoxy resin. (1 Gallon will cover 48 sqft seal coat.)
Step 2 - Pour epoxy onto surface.
Step 3 - Spread with a foam brush, or foam roller, or a bristle roller. Coat all surfaces evenly.
Step 4 - Allow to cure.

You don't need to worry about the epoxy being completely level (even though it should self level pretty well). The following flood coat will level it all off, leaving a perfect surface. Apply the flood coat 4 hours after the seal coat.

By Dallin Leach 1 comment


comments (1)

  • fred

    I didn’t get product mixed properly and it is not getting hard. Is there anyway to fix this? Also what can be used to clean or remove resign?
    REPLY from fgwarehouse: You can try acetone. It won’t be easy.

Leave a comment

Your email address will not be published. Required fields are marked *

Please note, comments must be approved before they are published

Just added to your wishlist:
My Wishlist
You've just added this product to the cart:
Go to cart page