Question: Can this epoxy resin be used to create live edge tables/ river tables?

Answer: Yes. This resin works great for river tables.

Question: How thick of a pour can I do at once?

Answer: Recommended pour thickness is 1/8”. Do not do more than a ¼” at a time. The resin will gel and start to harden before you can put the next layer on.

Question: How long should you wait before applying a second coat?

Answer: Once the resin has set up and cooled down, you can add a second layer. Depending on the ambient temperature and thickness, the actual time will vary. Typically, it is between 4 and 6 hours.

Question: Is this a 1:1 epoxy resin mix ratio?

Answer: Yes. It is 1:1 by volume.

Question: Where can I find the recommended coverage per gallon?

Answer: We have a calculator in one of the tabs where the size of your project can be entered to estimate how much epoxy resin is needed.

Question: How do I get rid of air bubbles?

Answer: A heat gun or torch can be used to help quickly eliminate air bubbles.

Question: Do I need to wear a mask when working with this resin?

Answer: It is not necessary but it is definitely ok to wear a mask when working with this resin. It has a slight odor.

Question: How long does it take to dry fully with a flood coat?

Answer: It takes 12-14 hours to dry to the touch, but full cure takes a few days. I would not place anything on the recently flooded piece for at least 3 days.

Question: Do you need to recoat right away or can you wait a week or so?

Answer: You really don’t want to wait more than 2 days before re-coating. If for some reason there is a delay longer than this, you will need to sand the surface with 120 grit sand paper and clean with acetone before adding another coat.

Question: How will this epoxy work on a table outside?

Answer: The resin will eventually yellow if left outdoors. This is the same with any epoxy resin out there. You can clear coat it with an automotive UV protected clear coat to prevent it from yellowing.

Question: How long does this need to stay in the mold when making a river table?

Answer: As long as it is hard and not sticky it can be taken out of the mold. Do not put anything on the surface for a few days.

Question: Will this product work in 65 degrees?

Answer: It will take longer to set up and harden at that temperature than it would at 90 degrees or higher. It will eventually set up and cure at 65 degrees.

Question: For scratch resistance, can I top it with polyurethane?

Answer: Yes. Just be sure to rough up the surface first.

Question: What happens if the product freezes during shipping?

Answer: The temperature of the product will need to be brought back up to around 80 F before using. If crystals formed, place the jug in a warm water bath until they disappear and the resin is warmed to 80F.

Question: Does this resin have an odor?

Answer: It has a slight odor.

Question: Is there any way to thin the material?

Answer: It is not recommended to thin.

Question: Is this epoxy FDA approved?

Answer: It is not.

Question: Is this product VOC free?

Answer: Yes, it is VOC free.