1/2″ Balsa Contoured CK 100 24″x48″ (8 sq ft)sheet

1/2″ Balsa Contoured CK 100 24″x48″ (8 sq ft)sheet

2lb Polyurethane Pour Foam

Rating:
97% of 100
  • 1:1 mix ratio by volume
  • Coast Guard approved for marine use
  • Resists water absorption
  • Ideal working temperature: 75 degrees
  • For flotation, filling gaps and voids, sound proofing and insulation
  • Bonds well with multiple pours
  • Once fully cured, polyester, vinyl ester and epoxy resins can be used
$24.95
Availability: In stock
SKU
3004070204
 

Details:

2LB Closed Cell Pour Foam is a 2-part liquid system with a 1:1 mix ratio.  It is U.S. Coast Guard approved for marine use and is great for use in dock floats and boat parts. It is an expanding polyurethane foam.  Once it is cured, the foam prevents moisture and absorption and will not be affected by solvents, oil or gas.  The waterproof foam sealant will have a buoyancy of approximately 180 pounds per cubic foot, and a density of 2.0 lbs/ft3. This product does not contain any CFC blowing agent or other Ozone depleting chemicals.

Uses:

-Flotation

-Insulation

-Soundproofing

-Filling gaps and voids

Application:

-Ideal working temperature is 75-77°F

-Wear appropriate safety clothing.

-Pour equal amounts of Pour Foam B into Pour Foam A

-Mix vigorously for about 30 seconds, either by hand or machine

-Pour foam will start foaming after 45 seconds and will completely expand in 7 minutes

-Once mixture begins to look cloudy, it should be poured immediately

-Once fully cured, foam can be cut or sanded as well as coated with polyester, vinyl ester or epoxy resins

Available Sizes:

Quart Kit (2 pints), ½ Gallon kit (2 quarts), 2 Gallon kit

Handling and Storage:

Store in tightly sealed containers in temperatures above 65°F

Prop65 Warning Icon WARNING: This product can expose you to chemicals including Ethylene Glycol which is known to the State of California to cause developmental problems. For more information go to www.P65Warnings.ca.gov

 

Write Your Own Review
You're reviewing:2lb Polyurethane Pour Foam
Your Rating

Question:  How much volume does this kit create

Answer: This kit creates a total of 8 cubic feet.

 

Question: Can I pour all at once or should I do it in batches?

Answer: I would do it in quart batches. It is tough to mix 2 gallons at once before some of it starts to cream.

 

Question: Does this foam adhere to the surface it is applied to?

Answer: It sticks to most things unless there is mold release, silicone, or oils used to keep it from bonding. Make sure to wear protective gear because it will stick to clothes, skin etc.

We found other products you might like!
Close