Epoxy Resin 2:1 Kit

Epoxy Resin 2:1 Kit

Table Top Clear Epoxy Resin- Proglas 1000

100% of 100
  • Tabletop Resin
  • Ultra Clear Epoxy Resin with UV Inhibitors
  • Scratch Resistant and Self Leveling
  • 100% Solids, NO VOC’s
  • Produces a Tough, High Gloss, Water Resistant Coating
  • Easy 1:1 Mix Ratio
  • Ships within one business day
Availability: In stock

Top Epoxy Resin

Proglas 1000 is an extremely clear, tough, high gloss UV epoxy coating formulated to produce a deep glass like appearance in a single layer on a sealed surface. Tabletop Resin, Ultra Clear Top Epoxy Resin, 100% Solids, Tough, High Gloss Resin here. Typically table top epoxy resin is used in table top applications. Two or more layers are often applied for added depth and protection. Proglas 1000 has been formulated for improved UV resistance to reduce yellowing and surface degradation from UV exposure. It has an extended “open time” which allows up to 50 minutes in the mixing container at 70º F and up to one hour working time on the surface being coated. Not recommended in freezing climates due to possibility of de-lamination.


  1. Pour equal parts by volume of the Part A and Part B into the graduated cups. (If the resin comes out more like molasses than syrup, the resin is too cold.)
  2. Mix the resin with a stir stick (tongue depressor, spatula, or paint stir stick). Stir steadily, scraping the sides and bottom. The resin will appear hazy but will clear up after 3 or 4 minutes.
  3. Apply the Seal Coat (not necessary for some surfaces): Pour some resin on the surface and spread it around with a foam brush or squeegee until a thin layer covers the whole surface. Allow the resin to cure for 4 hours before the flood coat is added. The seal coat will prevent most bubbles from forming during the flood stage.
  4. Apply the Flood Coat: Pour the mixed resin down the length of the surface. The resin will self-level and tools are not required. Allow the resin to run down the sides. Any drips that form along the bottom edge can be removed after the resin has cured. Each flood coat will be approximately 1/8” thick. If additional thickness or layers are needed, allow the previous layer to set up before adding more (typically 4-6 hours).
  5. Eliminating Air Bubbles: Once the flood coat has settled into place, take a torch or heat gun and wave the tool 6 to 8 inches above the surface. The bubbles will instantly start to pop. Repeat the process until all bubbles are gone.
  6. Keep the room between 75 to 80 degrees during the curing process. It will take about half a day for the resin to become tack free, but full cure isn’t complete for another 3 days. If the temperature falls below 75 degrees, the cure time will lengthen. If too cold, the resin may never fully harden.

For more instructions and troubleshooting tips go here.

Write Your Own Review
You're reviewing:Table Top Clear Epoxy Resin- Proglas 1000
Your Rating
We found other products you might like!